Alright, I'm going to use this thread rather than starting another. I'll be able to keep things a bit low key since I don't need a whole lot of attention; rather, a thread of progression from stock in FL to modded in the UK.
2013 2.0t RSpec, 6mt
Anyway. I'll start off with a list of parts that I either have in hand or are installed.
Triple A-pillar gauge pod
AEM Wideband O2
AEM Oil Temp
Greddy Informeter Touch
TWM Short Shifter
BLOX Bronze 490 Shift Knob
Custom Tail lights
Hood Vent Replacement
Ceramic Window Tint F20%/R35%
Exhaust Plug, Duh!
Weirtech Intercooler Piping
Short Ram Intake
3" Catless Turboback -> Aluminum Single Exit Exhaust
SFR 1.0(Beta) Tune
20" Incurve IC-S5 Matte Black
Stance Super Sport Coilovers
And I know that
, but I'll get to those. A lot of my parts haven't been installed since I've been away from my car for a bit. It's sitting at my parents house in Florida where they have hooked me up with installing a few...Cause they're pretty much awesome
El Stocko, chilling in Ft.Lauderdale at my brother's house.
Pre-tint action, clean though
Getting some loving from my Dad & Uncle.
Here's how the tip looks, it doesn't protrude as much as it looks. It's also pretty sexy though
And I feel that I should share this, it's a teaser shot from Flyryde that I got. It's been a long time coming, but I can't wait to mount these bad boys up.
As you can see, there are quite a few things not installed; but, I'm in no rush. I'm trying to take some leave for June-July and finish it up and then put her on a boat to sail over here. I'm hoping to make it for the Annual Keys Run down it...well..Key West.