Hyundai Genesis Forum - View Single Post - Engine Leash - Introduction
View Single Post
post #82 of Old 10-18-2016
Red Raspberry
I'd rather do it myself
Red Raspberry's Avatar
Join Date: Aug 2009
Location: Flat lands of Illinois
Posts: 18,245
Mentioned: 23 Post(s)
Tagged: 1 Thread(s)
Quoted: 3 Post(s)

I found some garage door spring safety cable in my garage. It already has a loop on one end, the other end has a flat steel piece with holes in it already. I drilled both holes out to .403" (Y bit) and the with a file elongated the one towards the engine so they slip over the strut bar mounting studs.

The cable is 10' long so I still need to cut it and put a loop on the brace end. You could just loop one end over the stud closest to the engine too I guess.

Still need a eye ring and a cable clamp. This piece of angle iron is a bit too long at 7&1/4". It's 1x1x1/8" cold rolled.

2010 Red 2.0L track

If the Pharaohs had duct tape, the Sphinx would still have a nose...."

Last edited by Red Raspberry; 10-18-2016 at 11:04 AM.
Red Raspberry is offline  
For the best viewing experience please update your browser to Google Chrome