Hyundai Genesis Forum banner

Search results

1-20 of 500 Results
Advanced Search
  1. What you need to know about intakes

    3.8 V6 Discussion 2013 and up
    The first thing you need to do is monitor the intake temperature.
  2. Clutch Pedal Clicking/Squeaking Noise

    General Discussion
    On the pedal end. It has a plastic tear drop shaped end. There are pivot points too.
  3. Potential New Genesis Owner with Questions about transmission

    General Discussion
    The bushings are still desirable. The BK2 has a better clutch and snycros. I think the bushing shape for the front has changed though. The rear mount probably is still the wish washy type.
  4. Potential New Genesis Owner with Questions about transmission

    General Discussion
    It's worth it with the bushing and fluid improvements. The BK1 clutch is suspect but OK until you add power. If it needs replaced the BK2 complete setup works great. Sometimes the BK1 flywheel beaks too and gets noisy.
  5. 2013 DRL Problems

    Electrical & Wiring 2013 and up
    I think the 2013 manual with 5 zip files is all that is available. I suggest using that to try and locate the relay and confirm the outputs after that to the individual DRLs. May be a splice that's bad.
  6. 2013 DRL Problems

    Electrical & Wiring 2013 and up
    It appears if one is on so is the other no mater what hidden logic from within the BCM. Assuming the above diagram is correct.
  7. What you need to know about intakes

    3.8 V6 Discussion 2013 and up
    The factory IAT is accurate as far as temperature is concerned. But is encased in so much plastic that there is quite the lag in temperature change. In fact you will be lucky to see 2F change on a pull. But with the fast acting IAT you will see a change almost immediately and go to ambient...
  8. 2013 DRL Problems

    Electrical & Wiring 2013 and up
    Any logic control is through the BCM. Do both DRLs go out when either turn signal is used?
  9. What you need to know about intakes

    3.8 V6 Discussion 2013 and up
    Yes.
  10. Gas mileage

    3.8 V6 Discussion 2013 and up
    I got 1.1 mpg above my long term average with that last tank of E0 91 octane Caseys. This tank will take a hit as I'm trying to get it to knock. 33.1 vs. 32.0 mpg
  11. Crank Pulley Wobble - How much is too much?

    2.0T Discussion 2008-2012
    Pretty common on Hyundai for the crank pulleys to start separating. I had to replace my Accent one last year. Got 110k miles on my Gen Coupe on e though. I looked it over last spring when it was off and no sign of cracking though.
  12. Rear Suspension, mechanic comment

    General Discussion
    If it's leaking oil it should be noticeable and would be bad. I have 110k on my Track struts and shocks but have a spare low mile OE backup set ready.
  13. Are the bumpers supposed to be glued?

    Exterior 2008-2012
    The corners have a piece that fits in and locks on the ends. But if you don't take it out right you end up rippng that piece off and then there is nothing to hold it. They may very well have glued it on. The right way is take out the 8mm hex head screw that is just in front of the wheel...
  14. Seat Belt Warning Light

    General Discussion
    the last couple of days i've been getting the airbag symbol on my Gen Coupe. Not all the time and sometimes on and off. But I just started carrying the fob in my pants pocket again (lost weight skinny jeans). And the fob I am using now has no other keys. So that may be why.
  15. anyone monitoring injector duty cycle with torque pro?

    General Discussion
    I tried it tonight on the Bk-A, BK-B, BK-C no luck. Tried the 3.8-A and it showed a value. Switched back to BK-A and it showed a value. But I lost my Oil Temp. I did see 85% for the duty cyle one time on a 2nd gear pull. That was the same as what it was a couple years ago.
  16. Brakes, Hard pedal when cold overnight?

    General Discussion
    Maybe the switch is stiffer when it is cold? It should be a two pole switch like the brake switch on the manual. One of the two contact should be closed at any time. I have a problem with the cruise control not setting sometimes and it is because the brake light switch needs adjusted. If i...
  17. anyone monitoring injector duty cycle with torque pro?

    General Discussion
    I can no long see the duty cycle. This disappeared with the one of the updates to the Advantage plug in or Torque. I can still see pulse width. These are fixed values from tables and not adaptive it appears.
  18. What did you do to your Genesis Coupe today?

    General Discussion
    Who this?????
  19. Brakes, Hard pedal when cold overnight?

    General Discussion
    Might need the brake light switch adjusted or replaced.
  20. OEM fog lights wont turn on, help!

    Electrical & Wiring 2013 and up
    I would make sure there is no output to the fog lights on the SJB before I would rule it out. Other than that it is going to take a scanner to look at the digital signals.
1-20 of 500 Results
Top