Hyundai Genesis Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 72 Results
  1. Engine 3.8 V6
    So long story short, threw a rod in my '13 genesis coupe 3.8 Track Auto, had a '13 genesis coupe 3.8 grand touring engine shipped to me because they're supposed to be the same thing. So now I'm halfway through the process and have the engine wiring harness from my track engine on the grand...
  2. Engine 2.0T
    So I've recently had a problem where my Forge BOV was getting stuck open due to the vacuum pressure not bleading off. What i mean is when i would let of the throttle the bov would lift relieving the pressure but the vacuum that pulls the piston up wouldnt let out leaving the bov wide open. Is...
  3. General Discussion
    Good afternoon everyone, What’s your thoughts on letting a turbo charged engine cool down for 2-3 minutes before shutting the engine down? I was told by many to let it cool down for a few minutes before turning it off to help preserve the turbo life. I was also told that was more of a thing...
  4. 3.8 V6 Discussion 2013 and up
    Does anyone know how to replace a 3.8 Gen Coupe Tensioner Pulley I can’t find any videos on it and I checked multiple forums and still can’t find any help, I have the oem replacement I just need steps on how to remove it from the vehicle! Pls and Thx
  5. General Discussion
    Hey everyone, I had my motor blow on me (shocker) at around 140xxx, anyways, I’ve decided to go the LS route, I’m leaning toward 5.3 with a 4l80e, custom driveshaft. I’ve never done an engine swap before nor do I have the tools space or time to do it myself so I’m going to have it done in a...
  6. 2.0T Discussion 2013 and up
    Hey! I have a weird issue going on with my newly purchased 2013 Hyundai Genesis coupe, it’s a 2.0T and only has 47,100 original miles on it. I’ve noticed a sound when turning off the key and wanted to see if y’all could help point me in the right direction?! It only makes this sound once I have...
  7. Engine 2.0T
    Hi I’m planning on installing a oil cooler on my 13bk2 2.0 but I’m looking for the remote location kit I should get but I’m a little lost on what I’d need specifically. Anyone know a good one?
  8. Engine 2.0T
    I have my 2.0t but it’s blowing white smoke on idle sometimes. It sometimes does it but it only seems to do it when I push the car a bit hard then I come home and park it and let it cool and boom white smoke. It smells like burning oil. But then if I rev it it’ll stop. I was thinking turbo, then...
  9. 3.8 V6 Discussion 2013 and up
    Hello everyone, after doing an oil change today on my coupe after getting it out of storage I noticed that when the sun hit the oil pan I could see very small brass coloured metallic fragments. I checked with a magnet and they are non-magnetic How concerned should I be? I’m just hoping that it...
  10. 3.8 V6 Discussion 2008-2012
    I bought my genny with full, clean oil on the dipstick. 3 weeks after that I checked it again, and the same was true, full and clean. 2 weeks later, I got some really bad rod knock and checked the dipstick, and there was no oil on it whatsoever. No signs of leaking or burning at all, and the oil...
  11. 3.8 V6 Discussion 2013 and up
    Went for a drive from Fort Lauderdale to Jupiter and back. When I came back home I smelled something burning from the car thinking it was my rear brake pads, but when I looked under my car saw oil residue on my tail pipe and smell the burning scent strong. I think there is a hose leak into the...
  12. Engine
    Hello everyone!! I just brought a replacement engine for my bk1 2.0t and I bought it with oem wire harness and no turbo ( still have old engine and turbo I can pull stuff off of) I wanted to know if there was anything crucial I need to make this go smooth with the least amount of repercussions...
  13. 2.0T Discussion 2013 and up
    My girlfriend has a 2.0t 8spd auto bk2, and on her way to work with cruise control on set at 75, her car started making a pretty terrible noise. She had to drive it for about 3 minutes like that after getting off of the interstate to a parking lot. She says the car had no CEL and no low oil...
  14. General Discussion
    Just ordered a set of Denso TT spark plugs (part number 4704) and If anyone knows the gap size these spark plugs need to be at for a bk1 2.0t? Also add an what is the torque spec the plugs need to be tightened at ? Thanks for the help in advanced.
  15. Engine 2.0T
    I’ve noticed that my fuel tank hums and is quite loud If Im on empty and it’s a hot day. Noise goes away when my tank is filled, problem seems like it can be avoided as long as it doesn’t run on empty. My car is a 2013 2.0t, am I in need of a new fuel pump soon possibly? I’ve read forums about...
  16. General Discussion
    Hi all, I have a 2013 3.8 Genesis Coupe with 57K miles on it. Last tuesday I had my oil changed and from then i've had my oil pressure light occasionally flicker once I get to my destination and i'm idle. This does not happen everytime probably 10% of the time, it has happened about 3 times in...
  17. 2.0T Discussion 2008-2012
    So I’ve seen across some threads that a lot of people use either 5w30 or 5w40 grade oil in their turbo genesis. I for myself currently run royal purple high mileage 5w30 in my BK1 and change the oil bout every 3000miles just to keep it clean, but I’ve seen some talk around here about the use of...
  18. 3.8 V6 Discussion 2013 and up
    My coupe recently through a rod.. and sitting where it is, I'm getting no use out of the vehicle I've bought.. I've been lurching about the forums and on FB groups to try and find anything on swapping a sedan engine into my coupe; the problem I'm running into is that I can't get like the hard...
  19. 3.8 V6 Discussion 2013 and up
    Anyone ever had any issues with a whine coming from the engine? Not the engine bay but specifically the motor. The noise goes away after an oil change (plus an oil additive I usually put in it, I think it makes a bit of a difference). The noise comes back after a few weeks of driving it and...
  20. Engine
    Hey, we need a 2011 3.8 engine, right around 100K would match what we had, but open to any good engine. We were unable to find one in or around the California Bay Area, where our mechanic could drive to and inspect. The ones we found come from questionable sources and no clear recourse. If you...
1-20 of 72 Results
Top