Hi All, I have a 2014 3.8GT and recently noticed that my fog lamps or my DRL strip isn't lighting up as it should be. If I recall correctly, the DRL strips should light up during the day when in the auto position. They currently don't light up no matter what setting. On top of this, at night...

I was Driving to go see my parents 3.8 R-spec and 2 min into the drive i goto turn on my A/c and got nothing cylced through some modes and all the sudden started to smell burning and saw smoking coming through my vents pulled over and the connector to my cooling fan was Melted. cant find the...

edit: honestly don’t know what the problem was but they work now. Mods can remove this post

Hey guys, I’m new to the gen coupe world. Bought it (2011 2.0 base) over the summer 2020 to work on. Recently, I swapped my cracked stock tail lights with bk2 with the Audi mod. All was fine. I bought a cheap backup camera to take place of one of the tag lights. Well when I was pulling on the...

So I’m not sure what happened, but I have no headlights or fog lights or the indicators, but everything else works fine, I checked the fuses their also fine...recently I’ve replaced the radio an the trunk lid.. I’m not to sure if they have anything to do with it or not... but can someone...

Passenger side tail light running light out All of the lights in the tail light are working BUT the running light (far left bulb). I just replaced the bulb and it doesn’t work. I tried replacing the brake light bulb and the NEW bulb I got. It works fine it’s just the actual running light it...

So today my angel eyes came in and I decided to install them. Everything went well until I had to wire from the angel eye module to the headlight harness. I soldered the power from the module to the yellow wire on the harness, and the ground wire to the black ground in the corner of the...

Hi everyone, so I have a 2010 Hyundai Genesis Coupe 2.0t Track and Im having a misfire in the cylinder closest to the cab. I bought all new sparks and coil packs but its still misfiring for some reason. We did a compression check and the cylinder is compressing correctly. We checked for spark on...

Just wondering if anyone can give me a solid answer on this question, I recently installed a pioneer avh series deck in my 2010 premium and I cannot for the life of me find an antenna adaptor that works for it. I've tried the metra 40-KI11 adaptor and it wasn't even close to fitting.

Good day. I bought the Pioneer AVH-Z5150BT for my Gen coupe and I understand that it needs the wiring harness but unfortunately it's not available in our country. I also know that the steering wheel control function will be lost and stock display will now only display AC settings. I'm willing to...

I previously installed HID headlights on my Genesis, but i decided to change things up and go from blue to purple so I had to get a different kit. Now when I turn my ignition on the lights come on like normal, but once I start the car they kind of flash then turn off and then I have to flash the...

Hi! I am finishing up my TK.com turbo kit installation. I have a boost gauge, wide band, and oil temp prosport gauges. I am hoping to find out where the best place, that's not terribly intrusive, is to run the sensor wires (and vacuum line) into the cabin on the 2013 3.8L. Would the 'noise...

So a few months ago I installed a new head unit in my car, I knew that I would be losing the outdoor temperature readout and didn't think that it was a huge deal but it has actually been driving me a bit crazy not having it. I think I may have found a way to get it back, but I wanted to get some...

Ok, so i need to install my 10s in the trunk before i get my sundown 15 but i need to know what and where i can splice the rcas into. i have looked through many post but none have been clear and i really don't want to use a loc because of the -db effect down low in HZ any help would be...

what do you guys think about this.. I was going to wire my positive wire to the 10a fog light fuse in the cabin. just take the wire put in in the fuse then stick the fuse back in. Then ground it to a bolt somewhere. This wont ruin the fuse or electrocute me will it??

I have a 2010 2.0t Premium Coupe, and i want to install laser projection lights like the ones shown below. I figured the easiest way would be to tap into the courtesy lights, since i only want them to come on when i open the corresponding door. Having done almost no wiring ever, i was curious...

First im sorry if something like this exists, i used search and couldn't find anything. I ordered those "weird looking tails" and began installing them. removed the oem tails no problem. wired up the left, installed it, no problem...

I dont care whats up on some tech site with schematics, and all that fun geeky stuff. This is better... its got my logo, its a shameless plug, and you can print it and glance at it to make hooking up anything you want a friggin breeze. Obviously if you're tapping into the wiring from the...

All parts will be described in this thread with my asking price which includes shipping/handling to the lower 48 states and will be listed in RED...Howeever I will be willing to ship to Alaska, Hawaii & Canada for additional shipping charges. All parts have been recently tested & are in good...

For those people that have installed bigger audio systems in their GenCoupe I would like some feed back. I'm only going to run a single Punch 500w amp bridged into a 2ohm load to a single Punch P3 DVC 4ohm sub good for 800w max. I already have mounted the sub in the rear deck & will be building...