Hyundai Genesis Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
So today my angel eyes came in and I decided to install them. Everything went well until I had to wire from the angel eye module to the headlight harness. I soldered the power from the module to the yellow wire on the harness, and the ground wire to the black ground in the corner of the harness. When I went to turn on my headlights, the side which I soldered into would no longer power up, nor would the angle eyes, but all the wires were soldered Back together just with the modules wiring mixed in too. Not sure where to go from here so any help would be appreciated. I looked through the forum and couldn’t find anything that helped me with this. Fuses are good and all the work was done on the driver side headlights.
 
1 - 1 of 1 Posts
Top