Hyundai Genesis Forum banner

Column dual Gauge Pod

2047 Views 7 Replies 5 Participants Last post by  dennis_david
Due to the lack of a pod that meets my needs and likes, I went and started mocking one up. I'm considering making a few of these but only if there's real interest.

I thought about carbon fiber but at least I'd prefer black with a stock-ish finish for this location.

What are your thoughts?

See less See more
1 - 8 of 8 Posts
It's nice but kinda gets in the way too much of speedo and rpm
Heres my setup, little different ;)

See less See more
and also u are blocking the fuel level gauge and water temp gauge...
i have mine similar to Kleindl's but my boost gauge is around the middle of the steering column, leaning to the left(speedo) block 200km/h+ on the speedo(which i don think i'll need if i ever go that fast XD)
It's nice but kinda gets in the way too much of speedo and rpm
It get in the way at speeds over 150mph and rpms are fully visible.

U mean aesthetics wise? Cause what counts is still fully visible...
and also u are blocking the fuel level gauge and water temp gauge...
i have mine similar to Kleindl's but my boost gauge is around the middle of the steering column, leaning to the left(speedo) block 200km/h+ on the speedo(which i don think i'll need if i ever go that fast XD)
If you lean a little forward or to the side you can see temp and fuel gauges.

u consider them to be that critical that can't be partially covered?

I thought the center dash dummy lights were more important... think about it
Kleidi definitely has a better setup for a DD. No gages blocked at all. If the car is mostly tracked then your setup is good but not better.
That's cool. I'm just throwing it out there.

Would something like an ATI epod be considered as an option?




Edit: tried posting a link w no luck
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top