Hyundai Genesis Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
Hi guys,

I don't know if anybody has encountered this. I have a 2015 3.8 with the navigation. The car has no problems connecting to my phone via Bluetooth. However, every time I turn off the engine and go to start it again it automatically defaults to aux or some other audio source. I then have to cycle through the modes to get back to "Bluetooth" as an audio source. Most other vehicles would just stay in the previous mode that was selected prior to the engine turning off. But somehow my car always select something else other than Bluetooth when the engine turns off. I've tried updating the firmware and Maps which I purchased from Hyundai without success.

Also sometimes as I'm cycling through the various modes or audio sources it just skips right over Bluetooth halves if it wasn't there however when I check on my phone and the car are successfully paired. Any input or suggestions will be greatly appreciated. Thanks
 

·
Bill
Joined
·
586 Posts
I just don't use the phone's music unless it's providing the nav.
Genny like her Usb stick better than that new fangled stuff the kids use...
 
1 - 2 of 2 Posts
Top